FOS Technologies Luminus NANO, User Manual

Page: 3 / 20

User’s Manual
2
1. WARNING
1.1 Safety Instructions
This product guide contains important information about the safe installation and use of this
product. Please read and follow these instructions carefully and keep this manual in a safe place
for future reference.
When unpacking and before disposing of the carton, check there is no transportation damage
before using the product. Should there be any damage caused by transportation, consult your
dealer and do not use the products.
The product is for indoor use only. Use only in dry locations. Keep this device away from rain and
moisture, excessive heat, humidity and dust. Do not allow contact with water or any other
liquids. The product is not designed or intended to be mounted directly on to inflammable
surfaces.
The product is only intended for installation, operation and maintenance by qualified personnel.
The product must be installed in a location with adequate ventilation, at least 50cm from
adjacent wall surfaces. Be sure that no ventilation slots are blocked.
Do not directly look into the led. It can cause harm to your eyes.
Do not attempt to dismantle and/or modify the product in any way.
Electrical connection must only be carried out by qualified personnel.
Before charging the fixture, ensure that the voltage and frequency of power supply match the
power requirements of the product.
A rechargeable lithium ion battery is built inside this fixture. Please avoid bumping or plunging, it
may cause fire or explosion. Never store the battery when fully drained. Always recharge
immediately when empty. Make sure to fully charge all fixtures before storing them. Partially
charged batteries will lose capacity. Fully recharge every 6 months if not used.
When charging fixtures in flight case, always charge with the case open. It is recommended to
charge at a temperature between 0°C and 35°C.
Please make sure the battery will be disposed of properly according to your local law when it
runs out of its life, so that to protect the environment.
This product is not designed for permanent operation. Consistent operation breaks will ensure
that the device will serve you for a long time without defects.
If this fixture is operated in any other way other than the one said in this manual, this device
may suffer damages and thus the warranty becomes void.