Forza FR304GN, Installation Manual

Page: 23 / 134

23
EN
Electrical Requirements
This appliance must be supplied with the proper voltage and frequency and connected to an individual, properly grounded
branch circuit, protected by a circuit breaker or fuse having amperage as noted on the rating plate. We recommend having
the electrical wiring and hookup of your appliance connected by a qualified electrician.
After installation, have the electrician show you where your main appliance disconnect is located. Check with your local
utilities for electrical codes which apply in your area. Failure to wire your cooktop according to governing codes could result
in a hazardous condition.
If there are no codes, your appliance must be wired and fused to meet the requirements of the National Electrical Code,
ANSI/NFPA No. 70 - Latest edition. You can get a copy by writing:
National Fire Protection Association
Battery march Park
Quincy, MA 02269
Before you plug in an electrical cord, be sure all controls are in the OFF position.
An adequate electrical supply and outlet must be used to operate the electrical parts of your appliance.
WARNING: Electrical Grounding Instruction Plug into a grounded 3 prong outlet. Do not
remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow
these instructions can result in death, fire, or electrical shock.
IMPORTANT: For personal safety, this appliance must be properly grounded.
The power cord of this appliance is equipped with a 3-prong (grounding) plug which must be used with a properly grounded
3-hole outlet with a standard 120 Volt, 60 cycle AC household current. If you do not have a 3-hole grounded outlet, have a
qualified electrician change your old one. A grounding adaptor will be needed to convert the old one until the outlet can be
replaced. This method is only temporary, and a qualified electrician should test it to be sure it meets requirements.
Do not under any circumstances cut or remove grounding prong from the appliance cord.
MODEL TYPE VOLTAGE CIRCUIT
RATING
FREQUENCY PHASE
30’’, 36’’, 48 ’’ Range
120 VAC 10 Amps 60 Hz
Single
An improper 120 VAC power supply will cause malfunction, damage to this
appliance, and possibly create a condition of shock hazard.