12
Installation Instructions
STEP 13: Connect Drain Line
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fi t 5/8”, 3/4” or 1” diam-
eter connections on the air gap, waste tee or disposer.
Cut on the marked line as required for your installation.
• If a longer drain hose is required, add up to 42” of
length for a total of 10 ft. to the factory installed hose.
Use 5/8” or 7/8” inside diameter hose and a coupler to
connect the two hose ends. Secure the connection with
hose clamps.
• Secure the drain hose to the air gap, waste tee or
disposer with clamps.
Drain Line Installation
FOLLOW ALL LOCAL CODES AND ORDINANCES.
• Connect drain line to air gap, waste tee or disposer
using either previously determined method.
METHOD 1 - Air gap with waste tee or disposer
METHOD 2 - High drain loop with waste tee or
disposer
TIP:
Avoid unnecessary service call charges. Always be sure
disposer drain plug has been removed before attaching dish-
washer drain hose to the disposer.
Total drain hose length must not exceed 10 feet for proper
drain operation.
NOTE
When connecting drain line to
dis poser, check to be sure that
drain plug has been removed.
DISHWASHER WILL NOT
DRAIN IF PLUG IS LEFT IN
PLACE.
Important
