19
Clean the machine if dirty. By cleaning the machine each
time after you finish your work, you will keep it in very good
Leave the machine in dry, warm area that is free from dust.
Drain the boiler completely, leaving valve no. 16 in its open
position. This valve can only be closed just before you start
your work.
If the machine is to be stored in temperatures below 0ºC
(32 F), it must be drained from all fluids (water, detergent,
fuel) using valves nos. 12, 13, and 14. Then, all the water
must be pumped out from the water system, by entering
the maintenance mode by pressing the Maintenance mode
button that occurs for several seconds in the upper part of
the display when the machine is started.
Afterwards, by pressing the button marked with orang ar-
row, the water pump will be run for 5 seconds pumping out
any remaining water from the water system into the boiler.
Repeat this procedure several times, watching if any water
is still present in the tube that supplies water into the wa-
ter filter, and in the filter itself. If you cannot see any water
coming out, do not start water pump any more to avoid dry
running.
The last step is to remove the water from the water filter by
unscrewing its plastic dome and draining the rest of water.
When dry, re-install the dome on the water filter.
6
7
8
9
10
11
Button used to start detergent
pump in maintenance mode
Service screen
Water filter
Water supply tube
from water pump
to water filter
Button used to start water
pump in maintenance mode
Button used to start wet
steam pomp in maintenance
mode
