Forney 95FI, Operating Manual

Page: 11 / 32

operated on inadequate or excessive power.
EXTENSION CORDS
For optimum welder performance, an extension
cord should not be used unless absolutely nec­
essary. If necessary, care must be taken in
selecting an extension cord appropriate for use
with your specific welder.
Select
a
properly grounded extension cord
that will mate directly with the ac power
source receptacle and the welder power cord
without the use of adapters. Make certain
that the extension cord is properly wired and
in good electrical condition.Extension cords
must
fit
the following wire size guidelines:
• 0..25
f t. requires
#12
gauge
• Do not use an extension cord over
25ft.
in length.
ASSEMBLING THE WELDER
The following procedures describe the process
required to assemble, install, maintain, and pre­
pare to weld with your new wire feed welder.
I
1
2
3