Fornelli PGA 45 FIERO BL, User Manual

Page: 14 / 24

Installation and operation instructions
HOBS
12
Turn over the hob avoiding not to damage
igniters and thermoelements of “gas cont-
rol”. Attach the sealing gasket “C” along the
entire lower edge of the hob which is to be
recessed.
Place the hob into the recess prepared, it
its center, supporting the hob from below.
Then, press on it to make it stably rest upon
the piece of furniture. Have someone to as-
sist you – in that case the work will be more
convenient and you will not move the sea-
ling gasket.
Attach the hob to the tabletop, using clamps
“A” and screws “B” (included).
If the sealing gasket “C” sits properly, it will
provide complete protection against penet-
ration of liquids under the hob. This is par-
ticularly topical for cleaning and care.
Fig. 7.
Connection to a gas supply system
These works can only be performed
by a representative of a state-run gas
service in your location. An act shall
be drawn up to confirm performance of
the works, on the company's letterhead
and in two copies, one for each party.
The appliance shall be connected to a gas
supply system according to valid norms and
regulations of the country, where a hob is
installed by qualified experts. At the end of a
supply pipeline there must be a safety valve
installed.
The appliance was subject to factory accep-
tance tests and set to that type of gas which
is indicated in the manufacturer’s plate. That
plate is on the rear panel of the hob, close to a
connecting gas pipe line. Make sure that gas
being supplied corresponds to that indicated
in the manufacturer’s plate.
If not, follow the instructions from “Setting to
various types of gases”.
To ensure maximum efficiency and minimum
gas consumption, make sure that gas supply
pressure has parameters as follows:
Main pipeline gas: G20 - 2,0 kPa;
Liquefied gas: G30 - 2,8-3,0 kPa,
G31 - 3,7 kPa ,
(attention: these values may slightly vary).