Fornelli PGA 45 FIERO BL, User Manual

Page: 13 / 24

Installation and operation instructions Installation and operation instructions
HOBS
11
Please keep in mind:
To ensure sufficient air circulation above the
gas ob, it is required to keep a minimum dis-
tance of 10 mm to any drawer, any partition
wall, or any oven that may be located beneath
the hob.
Should the as hob be installed combined with
an oven, you have to follow the guidelines of
the oven manufacturer which is to ensure
required ventilation as shown in Figure 7. At
that, gaps “C” and “E” shall make 30 mm at
least.
Any way, if you are going to use a gas-fired
oven, both parts of the equipment shall be
connected to the mains and gas pipeline
separately.
Gas hob attachment
to the tabletop
Cut out a recess in your tabletop on the ba-
sis of dimensions shown in Figure 5.
Wood fibres used for manufacture of table-
tops can quickly swell if exposed to mois-
ture. In this connection, a special adhesive
or sealant shall be applied onto the side
surface of the recess cut to protect it from
vapors or moisture condensed on the un-
derside of the tabletop.
Prior to installation of the hob into a recess
prepared (Figure 6), it is necessary to attach
a self-adhesive sealing gasket “C” onto the
lower edge of the hob. The gasket shall be
uniformly attached along the entire perime-
ter, without breaking or overlapping that.
For that, you should remove support grids,
gas burner cap and flame spreaders.
Fig. 6. Fig. 5
510
450
426
120 min
430
55
58
490
485