Formula R1 Racing, Operating Manual

Page: 9 / 19

24
1.2 Installing the pump
- The pump can be supplied in a right-hand (rh) or left-
hand (lh) version for installation on both sides of the han-
dlebar.
Models R1 – R0 – T1 – R1 RACING – R1S have just one
collar that is interchangeable and used with the word “UP”
facing up.
Model RX – T1S has a collar for the right-hand solution
(rh) and one for the left-hand solution (lh).
As a result, the side on which it will be used must be
specified when placing the order.
The installation steps are similar for both models:
- Fit the pump body
4a
to the handle bar positioning it as
shown in the figure and orientating it in the desired position.
- Fix the pump body
4a
by mounting the collar
5a
so that
the indication
“UP”
faces the upper part (as shown in the
figure). First tighten the upper screw
5
to a torque setting
of
2.5/3 Nm±5%
and then screw
5b
to a torque setting
of
2.5/3 Nm±5%
using 3 mm (R1/RO) and 4 mm (RX)
hex. socket wrenches.
If the hose length needs to be adjusted, contact the manufacturer, if not proceed with the posi-
tioning of the hose on the bicycle, carefully following the instructions given below:
- the hose needs to be attached to the fork or frame in a way that does not interfere with the free
flow of fluid through the hose;
- the hose should not make curves smaller than a 20 mm radius and should not interfere with
any moving part of the bicycle.
5b
4a
5
5a
5b
5
5a
RX
5b
4a
5
5a
5b
5 5a
R1Racing
5
5b 5a
4a
5
5a
5b
RO
5b
4a
5
5a
5b
5 5a
R1