30
G
6. OPERATION OF THE LAMINATOR
6.1 Lamination
The lamination may start only after the foil is installed, the pressure of the winding is set, the
temperature and the speed are set and the tilting over equalizing roller (Figure 10-D) is
secured in the working position by the arrest lever (Figure 10-C).
Turn on the main switch and press the HEATING & READY button on the control
panel and wait until the set temperature is achieved. After that, turn on the switch of the
motion (Figure 7-5). When the foil and laminated format are released, it is necessary to take
care that the laminated formats are always overlapping (the overlap must be between the
cutter marks and edges of paper) and that the foil is always thinner than the paper. Place the
left edge of the paper onto the sliding side rail (B) on the feeding table.
A)
Feeding table
B)
Sliding side rail with arrest
Figure 18
It is suitable to place a working board behind the laminator and separate the formats
immediately by tearing them apart, place them on top of each other with the foil facing down.
Then, it is recommended that the pile of sheets is covered with a flat board and loaded
properly for several hours. Recommended accessories – automatic sheet separator FOLIANT
SEPARATOR 520/720 with a container for laminated sheets.
6.1.1 Two-sided lamination
If required, the two-sided lamination is to be performed in two stages.
1.
Step – standard one-sided lamination setting the bar against curling of sheets lower.
Sheets exceeding 200g/m² may be laminated without using the bar for sheet curling in
the first stage.
2.
Step – lamination from the other side without using the bar against curling of sheets.
This procedure offers even, two-side laminated paper sheets.
6.3 Automatic mode of temperature and speed control
B
A
Summary of Contents for Foliant 370T
Page 2: ...2...
