23
Perform the installation of the selected foil when the heating is turned off (the HEATING &
READY button, control panel), both LEDs (3, 4) are turned off and the equipment is cooled
and the foil roll is inserted. Insert sufficiently large format of paper along with the end of the
lamination foil taped onto it into the area between the first pair of rollers (A, B). Then, set the
lowest speed of motion on the equipment. Then turn on the main switch (10). After turning on
the engine of the motion (the "MOTOR & PAUSE" button (Figure 8-15)), the foil roll with
the sheet of paper starts moving and winding off. It is necessary to direct the paper with the
foil so that it winds around the additional roller (K), over the moving equalizing bar (J) up to
between the back pair of the stretching rollers (I). For this, the switch for the engine
operation, regulator of the motion speed, or back operation of the rollers may be used as help.
When the sheet of paper with foil glued on it exits the equipment, turn off the motion engine,
release the pressure on the back rollers (I) by releasing the arrest (O) and stretch the foil by
pulling it inside the equipment. When stretching the foil, errors in the side motion may also
appear. After balancing the foil, pull both back rollers towards you by the arrest (O). Expert
care is necessary to perform this work.
Summary of Contents for Foliant 370T
Page 2: ...2...
