2
SETUP
Fig. 1
Fig. 2
Fig. 3
2. Extend connecting slider and slide into slot on
sealer section of base, lining up the screw holes
wih the holes in the top of the base (Fig. 2). Insert
the leading two screws first, do not tighten down at
this point. Align third screw hole in the slider with
the top cover and insert screw. Tighten all three
screws into place.
1. Align the 2052IL with the pins located on the
alignment base and lower into position. (Fig. 3)
Caution:
Two people should lift and lower the
2052IL.
1. Place two parts of alignment base face up.
(Fig. 1).
Alignment Base, Pressure Sealer Section
Alignment Base, Printer Section
Connecting slider
Alignment Base Setup
Sealer Setup
Summary of Contents for FD 2052IL AutoSeal System
Page 1: ...FD 2052IL AutoSeal System OPERATOR MANUAL FIRST EDITION 12 2007...
Page 2: ......
Page 4: ......
