04
Cut-True 22S
1~, 120V, 60Hz
8A< Fuse <10A
1.0 mm
2
1.0 mm
2
Model
Voltage
Fuse
Cable diameter (Input)
Underground Cable
Cut-True 22S
1~,
120
V,
6
0Hz
8A< Fuse <10A
1.0 mm
2
1.0 mm
2
Safety function inspection before use:
Trouble Shooting:
Maintenance and Lubrication:
Installation of electrical power supply:
Please follow up the underneath specification of power supplier to set up the machine and main power.
1. Be sure to check the safety functions before operation and after replacing the blade.
2. The safety devices (SQ1 and SQ2) are designed in accordance with the EN 60947-5-1-3 requirement and the
electronic requirement EN1088.
3. The front safety guard is controlled by SQ1 and SQ2, which follow the requirement EN954-4 category sub.3. The
machine and blade will automatically stop when the safety guard is open or disconnected. In contrast, the machine
can be operated by pressing the two enable switches simultaneously.
1. Use a dry cloth to wipe the surface. Do not pour water directly on the machine.
2. Do not use a brush, acid or solvents, such as benzene, hot water…etc. Because it will damage the paint.
3. All movable parts need to be lubricated and oiled from time to time. These parts must be cleaned and free of paper
dust and oil deposits before lubricating.
1. The blade doesn’t move. Check if the main motor magnetic contact is activated.
2. Powering off: Check the power source and all the control circuit fuses.
3. Overload. Wait until the breaker automatically resets, it takes around 30- 60 seconds. The indicator light will be off.
Please reduce the paper pile or change to a sharp blade.
4. The machine does not work after closing the front safety guard. Press the two enable switches simultaneously again,
and check to see if the safety guard is completely closed.
5. If the circuit board needs to be changed, please follow these steps
:
a. With the power off, remove the old circuit board and put in a new circuit board.
b. Once the new circuit board is in place, turn the power on. The message “HOME” will
appear
. Move the
back-gauge to the end until the message “DOWN” appears.
c. Turn the back-gauge crank to return the back-gauge into the operating position. The ruler indicator needs to be at
the position of 30 cm, and make sure the scale on the back-gauge crank is located at the 0 position.
d. Press the reset button for a few seconds until the figure 30.00 shows up on the screen.
e. After you see “30.00”, cut one sheet of paper and make sure it precisely matches 30cm.
6. If there are any other problems, please contact your dealer.
