Formax 6204 Series, Maintenance Manual

Page: 43 / 53

Diagnostics
Start test
This test checks if all motors, clutches and sensors are correctly connected. The system test derives the status of
the actuators and clutches by briefly activating the actuators and then measuring the current.
Error counters
In the Error counters menu a list is given of the top 40 occurred errors. The errors are sorted based on quantity.
That means that the errors occurring most frequent are in the top of the list.
Press “clear” to clear all error messages.
Last error list
This menu displays the last 50 errors that occurred. Besides the error code also the job number and the corresponding
counter value are given.
Press “clear” to clear all error messages.
Online service
Server settings
Use this menu to enter:
• the IP address of the server
• the suffix
• the server port of the server
Reset CB data
Use this menu to clear the data on the communication board, and to reset the status of the communication board
to “undeclared”.
Once the communication board has been reset, it can be used in another system. As soon as the communication
board is installed in another system (i.e. during a board replacement), it will be automatically reset.
Test CB
Select Test CB to check the following:
• the serial port
The system checks if the RS-232 serial port and cable are working correctly. Connect the special test plug,
and then select Test CB. The special RS-232 test plug has pins 2 and 3 jumpered together. During the test a send,
response is sent through the cable and plug (Rx, Tx).
• the modem
The system checks if a modem is present and if there is a dial tone.
• the FRAM memory {wat wordt gecheckt?}
• the Flash memory {wat wordt gecheckt?}
• the real time clock
The system checks if:
- the communications board has a battery, and the battery is working correctly.
- the communications board clock is working correctly.
Fail or Pass will be displayed for each item depending on the result of the test.
40
4
063.1
Service
Guide