—
58
—
Tent Camper Owner’s Manual
1. gest that you consult your dealer and / or owner’s
manuals included with your camper for operating
and maintenance information.
r
etUrn
to
tHe
oUtside
For
Final
set
-
Up
2. To attach the grill, remove it from the box and
assemble according to the manufacturer’s instruc-
tions. Begin by installing the grill base on to the
mounting bracket located on the side of the tent
camper. To attach the grill base to the exterior wall,
be sure that the lip on the extrusion across the back
of the base fully locks into place on the extrusion
mounted to the camper sidewall. Place the grill on
the base and attach the LP gas line provided from
the opening on the side of the camper to the grill.
A quick disconnect fitting on the grill is provided
for this purpose. When connecting the grill to the
LP gas supply, the LP valve on the disconnect fit-
ting must be in the OFF position (valve handle at
a right angle to the gas line). To attach the quick
disconnect, hold the gas line, pull back on the outer
connecting collar and insert over the grill connec-
tion. When connected, turn the gas valve to the
ON position (valve handle in line with the gas line).
Don’t forget to remove the grill before closing up
the camper.
C
losing
i
nstrUCtions
3. at this time, refer to the optional a-frame aw-
ning/screen room closing instructions at the end
of this section, for disassembly instructions if you
purchased this option.
the flagstaff harD siDe CaMping
trailer Must be in the CloseD position
to toW.
4. Begin closing the camper. Start with disconnecting
the door sections by releasing the latch mounted to
the lower door section from the catch mounted to
the upper section.
5. Next, release the latch on the right at the top of the
door side wall from the plate mounted on the ceil-
ing. Then release the two latches at the top of the
off door side wall from the plates mounted on the
ceiling. Lower the off door side wall until down flat.
6. Now, release the latch on the left at the top of the
door side wall form the plates mounted on the ceil-
ing. With the upper section of the door open, step
into the door opening of the wall. While holding
the upper section of the door, lower the door side
wall gently until down flat.
7. Open the lower door section, and exit the camper.
Close the upper section of the door and then close
the lower section.
8. Lift the handle on the right roof section up with
firm action, holding it up until the left roof sec-
tion disengages form the groove on the right roof
section.
9. Now, fasten the safety latches on both sides to the
top roof section and raise the (4) stabilizer jacks up
to the closed position.
