6
ASSEMBLY INSTRUCTIONS
NOTE: Tool Required for Assembly: phillips screw driver ( NOT included)
NOTE:
Do not tighten bolts completely.
1. Carefully unpack all parts from the box, compare parts with package content listed above, make sure all
parts are present before beginning assembly of product. If any part is missing or damaged, do not attempt
to assemble the product. Contact customer service for replacement parts.
2. Place table top (B) on a non-abrasive flat surface to prevent scratching. Attach right panel (D) to table top (B)
with bolts (AA) and washers (BB) using hex screw driver (CC), make sure the control panel just covers up the
notch on right panel (D). Attach left panel (I) to table top (B) with bolts (AA) and washers (BB) using hex
screwdriver (CC). (see Figure 2).
4. Attach base support (E) to left panel (I) and back panel (C) and right panel (D) with decorative foot (F), (see
Figure 4).
NOTE:
DO NOT tighten the screws completely.
Hardware Used:
AA Bolt (M6 x 15) x 4
BB Washer (M6) x 4
CC Hex screw driver x 1
Figure 2
control panel
NOTE:
DO NOT tighten the screws completely.
3. Attach back panel (C) to right panel (D) and left panel (I) with bolts (AA) and washers (BB) using hex
screwdriver (CC), (see Figure 3).
Hardware Used:
AA Bolt (M6 x 15) x 4
BB Washer (M6) x 4
CC Hex screw driver x 1
Figure 3
I
B
D
CC
AA
BB
D
I
CC
BB
AA
C
