Figure 17
LIGHTING INSTRUCTIONS
1. Depress control knob slightly and turn to “OFF”.
2. Depress control knob and turn to “ON/MIN”.
3. Continue to depress the ignition button for 15 seconds.
4. If the burner does not light in 15 seconds, release the
knob and it will pop back out. Wait 5 minutes before
attempting to light the burner again, repeat step1 to 3.
1. Depress control knob slightly and turn to “OFF”.
TO TURN OFF GAS
INSTRUCCIONES DE ENCENDIDO
PARA CERRAR EL GAS
1. Presione ligeramente la perilla de control del gas y gírela a la
posición “APG” (apagado).
2. Appuyer sur le bouton de commande et tourner à “ENC./MÍN.”
(encendido/mínimo).
3. Siga presionando el botón de encendido durante 15 segundos.
4. Si el quemador no se enciende en 15 segundos, suelte la perilla
y esta volverá a su posición hacia afuera. Espere 5 minutos antes
de intentar encender el quemador nuevamente, repita los pasos
1 al 3.
1. Presion ligeramente la perilla de control del gas y gírela a la
posición “APG” (apagado).
OFF (APG.)
MAX
(MÁX.)
1 AAA
1.5V
IGNITOR
( Encendedro )
ON/MIN
(ENC./MÍN.)
12
BATTERY
BATTERY
WARNING:
Make sure the control knob is in the “OFF” position. Unscrew the push button cap on the ignitor module located
on the control panel to access the battery compartment. The ignitor module requires one AAA size battery (See
Figure 17), BATTERY IS NOT INCLUDED.
1. Please observe proper polarity and use the correct battery type when placing or replacing the battery.
Improper installation could result in ignition failure.
2. Please remove the battery if consumed or if product is to be left unused for a long period of time.
1. Always perform the leak test as described below before lighting this appliance or each time the
cylinder is connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3. Conduct the leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use this appliance until any and all leaks are corrected. If you are unable to stop a leak,
disconnect the propane supply. Call a gas appliance service shop or your local propane gas supplier.
To prevent fire or explosion hazard when testing for a leak:
cylinder-regulator connection (Figure 18)
gas valve-bellows connection (Figure 19)
