ES-2810 ATM Uplink Module User Guide
4 - 5
Configuring the Module
4.2.4 Changing the Module Mode
The ATM Module can operate in stack or stand-alone mode. The default is stack
mode. Use of these modes depend on whether the ATM Module is connected to a
Matrix Module in a stack or only installed in a single switch. To change the oper-
ating mode, complete the following steps:
NOTE
Changing the module mode will
automatically save your configuration and
reset the switch. It is recommended to
backup the configuration to disk before
changing the mode.
NOTE
A switch with an ATM Module in stand-
alone mode will not be recognized as part of
a stack.
1. With the ATM port selected from the display, select Configura-
tion>Port Setup from the main menu or right-click the ATM port and
select from the pop-up menu. The Setup window displays.
2. Select the Module tab.
3. Select one of the following options:
• Stand-alone: ATM Module is connected to a switch.
• Stack mode: ATM Module is connected to a Matrix Module in a
stack. This is the default.
4. Click OK when finished.
