1.
Place the cap just forward of the key
cylinder.
2. Applying pressure to the cap, move it
forward until it is in place. You may
hear a snap as it engages.
Make sure you have properly installed the
cap by trying to move it rearward.
Replacing the Battery
Note:
Refer to local regulations when
disposing of transmitter batteries.
Note:
Do not wipe off any grease on the
battery terminals or on the back surface of
the circuit board.
Note:
Replacing the battery does not erase
the programmed key from your vehicle. The
transmitter should operate normally.
A message appears in the information
display when the remote control battery
is low. See
Information Messages
(page
102).
The remote control uses one coin-type
three-volt lithium battery CR2032 or
equivalent.
E218400
1.
Push the release button and pull the
key blade out.
E218401
2. Twist a thin coin under the tab hidden
behind the key blade head to remove
the battery cover.
50
Fusion (CC7) Canada/United States of America, enUSA, First Printing
Keys and Remote Controls
