CREATING A MYKEY
Use the information display control to
create a MyKey:
1.
Insert the key you want to program into
the ignition or, if the vehicle is equipped
with push button start, put the
intelligent access key in the backup
slot. Backup slot information is located
in a different chapter. See
Starting
and Stopping the Engine
(page 144).
2. Switch the ignition on.
3. Access the main menu on the
information display controls and select
Settings
, then
MyKey
by pressing
OK
or the
>
button.
4. Press
OK
to select
Create
.
5. When prompted, hold the
OK
button
until you see a message informing you
to label this key as a MyKey. The key
will be restricted at the next start.
The key is successfully programmed. Make
sure you label it so you can distinguish it
from the admin keys.
You can program optional settings for the
key(s). Refer to
Programming/Changing
Optional Settings
.
Programming/Changing Optional
Settings
All programmed keys can be cleared within
the same key cycle in which a key was
programmed, otherwise an admin key is
required to clear the keys. See
Clearing
All MyKeys
(page 49).
You can access the optional settings
through the information display control.
1.
Switch the ignition on using an admin
key.
2. Access the main menu and select
Settings
, then
MyKey
.
3. Use the arrow buttons to get to an
optional feature.
4. Press
OK
or
>
to scroll through
settings.
5. Press
OK
or
>
to make a selection.
CLEARING ALL MYKEYS
You can clear all MyKeys within the same
key cycle as you created the MyKey. If you
switch your ignition off, however, you will
need to use an admin key to clear your
MyKeys.
Note:
When you clear your MyKeys, you
remove all restrictions and return the keys
to their original admin key status.
To clear your MyKey settings, use the
information display to do the following:
1.
Access the main menu and select
Settings
, then
MyKey
.
2. Scroll to
Clear All
and press the
OK
button.
3. Hold the
OK
button until
ALL
MYKEYS CLEARED
displays.
49
Fusion/Mondeo (CC7)
MyKey™
