Hardware Upgrades and Accessories
Installation
2 - 18
PENT/CPCI-721
SVGA-AccKit
1. Uninstall I/O board
(see the “Removing the I/O-721 from the PENT/CPCI-721” section
on page 2-23)
2. Plug VGA-IO720-4 onto respective I/O board connectors
(see Figure 6 “Location Diagram of the I/O-721” on page 2-8)
3. Fasten VGA-IO720-4 onto I/O board with four screws delivered
together with accessory kit
(see locations marked as V1, V2, V3, and V4 in figure below)
Figure 11:
Mounting Points of the VGA-IO721-4 on the Bottom of an I/O Board
After the hardware installation is completed and the PENT/CPCI-721 is
installed in the CompactPCI rack, enter the BIOS Setup and select VGA
as video system type (see the “Boot Configuration in Setup” section on
page 4-5).
I/O board CompactPCI Interface
VGA-IO720-4
V2
V3
V4
V1
Summary of Contents for PENT/CPCI-721
