FOR-A HVS-XT100, Operation Manual, Page: 20 / 236

20

Rear Panel
No. Name Description
Refer to
sec.
1 Power Switch Switch used to turn unit power ON / OFF.
2 MODE SW For maintenance use. Do not change.
3
DC IN1 Supply power (12 V DC) using the supplied AC adaptor.
3-3
DC IN2
Optional power supply (HVS-XT110PSM) for power
redundancy.
Supply power (12 V DC) using the supplied AC adaptor.
4 SDI INPUT Used to input HD/SD SDI video signal. 12 inputs (BNC) 5
5 SDI OUTPUT
Used to output HD/SD SDI video signal. 8 outputs
(AUX1-8) (BNC)
6
6 HDMI Used to output an HDMI output. (Type A connector) 6-5
7
RS-422 (1)
Used to connect peripheral devices such as
HVS-30RU,VTR/VDCP devices, Routers.
(9-pin D-sub, female)
2-4-1
RS-422 (2)
GPI IN/
TALLY OUT Used for GPI input/output and Tally output.
(25-pin D-sub, female)
20-1-1
8 ARCNET
Optional Arcnet LAN port (HVS-XT100ARC).
One port is used for HVS-AUX bus Control Box
connection.
The other port is used for loopthrough connection. It must
be 75-ohm terminated if not looped-through.
20-5-1
9 LAN
Ethernet port used for image transport and web control
100BASE-TX/1000BASE-T (RJ-45) 12-4-1
21
10
GENLOCK
(REF IN
REF OUT)
Used to input and output a genlock signal; tri-level sync or
black burst. (BNC)
The center terminal is used for loopthrough connection. It
must be 75-ohm terminated if not looped-through.
18-3
11 Cooling Fan
Used to air cool the unit to prevent overheating. Do not
block the ventilation openings.
18-6-1
REF OUT 1 1 2 3 4 5 6 7 8 2 3 4 REF IN
HDMI OUT
A UX
5 6 7 8
A UX
LAN
SDI INPUT
9 10 11 12
SDI I NPUT
GPI IN/T A LLY OUT
DC1 2V IN
1 2
MODE SW POW ER
OFF ON
GENLOCK
RS-422
1 2