53
6-8. AUX LINK
In the AUX-LINK function, the auxiliary outputs are grouped, and the master and slave outputs
are set to allow all slave output signals to be switched simultaneously by simply selecting the
master output signal. A group consists of one master output and up to three slave outputs.
Seven auxiliary output groups can be set. Examples of AUX LINK settings and operation are
shown below.
6-8-1. Creating AUX Output Link Groups
(1) Open the [SETUP - FUNCTION] menu. Turn F1 to select AUX LINK. Press F1 or the
page down button to display the AUX LINK menu.
SETUP :>M/E_KEY >VIRTUAL >
AUX LINK
FUNCTION:
FUNCTION:ENABLE : : 1/3
AUX LINK: =OFF : :
(2) Press the page down button again to go to the [AUX LINK - AUX GRP] menu page.
FUNCTION:SELECT:MASTER: SLAVE SEL/AUX : 2/3
AUX GRP : =1 : =AUX1:1=AUX2 2=AUX3 3=AUX4
(3) Turn F1 to select a group to be set from 1-7
(4) Turn F2 to set the auxiliary output serving as the MASTER. Available outputs are shown
below.
Master Output
AUX1-8, PGM, PST
ABUS, BBUS, KEY1, KEY2, DSK1, DSK2
(5) Select the auxiliary outputs (up to three) serving as the SLAVE linking to the MASTER
output. Available outputs are shown below. Press F3 and then turn F3 to select an output
for Slave 1. Press F3 and then turn F3 to select an output for Slave 2. Select an output for
Slave 3 in the same way.
Slave Output
(Normal link)
Same options as Master Output.
Note that video set as Master cannot be selected for
the Slave.
The A or B bus cannot be set for Slave when the Program or Preset bus is selected for Master.
In the same way, the Program or Preset bus cannot be set for Slave output when the A or B
bus is selected for Master.
6-8-2. Creating Signal Link Groups
(1) Press the page down button to go to the [AUX LINK - LINK GRP] menu.
FUNCTION:SELECT:MASTER: SLAVE SEL/AUX : 3/3
LINK GRP: =1 : =IN01:1=IN02 2=IN03 3=IN04
Available Signals
BLK, IN01 to 12, STL1, STL2, STK1, STK2, CKFL,
CKKY, EFF1, EFF2, CB, MAT1, MAT2
(If AUX1-8 is selected for the
MASTER or SLAVE bus)
PGM, PVW, CLN, MEKY, MV
