FOR-A HVS-AUX16, Operation Manual

Page: 26 / 51

26
5. Menu Operation
There are several operational settings which need to be made using the front panel LED menu
display and the menu control. Explanations on making settings and what settings can be made at
the front panel are contained in the following sub sections.
5-1. Making Settings
The general procedure for making settings using the LED display and the display control are as
follows. Note that the LED display can only display 4 characters at a time, so the names for each
setting are given in abbreviated form at the display. (See the following pages for settings table
and names.)

To make settings:
1) To enter the Setup menu, press and hold down menu control for 2 seconds. If the front panel
is locked, press and hold down menu control for more than 10 seconds to enter the setup
menu.
When entering the Setup menu, the CONT indicator and LED Menu Display should blinks.
2) Turn menu control (CONT indicator will flash) until needed setting is visible in menu display.
(See the following pages for a list of settings available and display order.)
Turn menu control
3) Once required menu item is displayed, press menu control as indicated below to select that
item for change.
Press menu control
4) Setting currently made for selected item will appear in menu display. Turn menu control
again to change currently displayed setting.
5) When correct setting is visible in display, press menu control again to input and store the new
setting.
6) Turn menu control until EXIT is displayed then press menu control to exit menu setup.
IMPORTANT
Press and hold menu control for 2 seconds at anytime during this procedure to restore
the previous settings. Press and hold menu control for more than 3 seconds to exit the
menu list and to not apply new settings.
Note that if no operation is performed (control pressed/turned, etc.) for 30 seconds
during following procedure, unit will automatically exit setup menus.
A U X ?
POWER
CONT
A U X ?
POWER
CONT
USO
RESTRITO