Foppapedretti TreSystem, Instruction Manual

Page: 24 / 28

Slacken the shoulder straps by pressing the harness release button (1) at the same
time, pulling both shoulder straps forward with your other hand (2) Fig.9 .
Press the red release button (3) and unhook the harness.
Remove the shoulder straps from the small seat, cover and chassis in plastic, by
pulling each shoulder strap, including buckle, through its corresponding slot Fig.10 .
Do not remove the shoulder straps from the loop of the harness adjuster strap.
Insert the shoulder straps into the chosen slots, passing through the slots of the
chassis in plastic at first, then through the cover and at last the small seat Fig.11 Fig.12 .
The harness has 2 positions. The straps should be put into the nearest slots above the
shoulders of the child.
Make sure that there are no twists of the webbing and that the shoulder straps are
correctly inserted in the loop of the harness adjuster strap Fig.11, Fig.13 .
Now place your child in the car seat and check that the shoulder straps are in the
correct position for your child’s shoulder Fig.14 .
FITTING YOUR CAR SEAT INTO THE CAR
WARNING: This car seat can only be fitted into the passenger seat of a car with a lap
and diagonal seat belt and no air bag.
THE TYPE OF APPROVED SEAT BELT YOU MUST HAVE
Fig.15
Your child seat can only be installed rearward facing using a lap and diagonal seat
belt in the front or rear passenger seat of the car Fig.16 .
INSTALLATION
-
Push the child seat facing rearward firmly against the backrest of the car’s seat
Fig.16 .
-
Route the lap section of the adult safety belt through the lap belt guides and fasten
the car seat belt Fig.17, Fig.18 .
-
Place the diagonal belt in the diagonal seat belt guide at the back of the seat Fig.18 .
-
Take out all the slack in the seat belt, ensuring that there are no twists or kinks in the
seat belt Fig.19 .
THE HANDLE POSITIONS
To adjust the handle from one position to another, pull out both sides of the handle
on the swivel point; rotate the handle forwards or backwards into the desired
position:
The carry handle has four positions:
- Forward in the car Fig.20 .
- Straight up for carrying Fig.21 .
- Against the car seat for rocking Fig.22 .
- All the way down to support baby for feeding and play Fig.23 .
- Stop rocking Fig 24 .
Always ensure that the handle is locked in position and that the harness is correctly
fitted and the buckle fastened before lifting your car seat.