3000 Fifth Wheel Instruction Manual
14
5.5 Bolt positions
In all cases the Fifth wheel equipment should be mounted using
the mounting holes positioned as supplied. Where Pre-Drilled holes
are supplied in the vehicle chassis or fifth wheel equipment these
should always be used. If equipment appears to require further
modification then the Fontaine Technical Department should be
consulted prior to any alteration of the equipment.
5.6 Positioning of equipment on vehicle
Fifth wheel Equipment should always be fitted to the vehicle using
the vehicle manufacturer’s fifth wheel position as this determines
the correct axle loading and compliance with national legislation.
In the case of sliding fifth wheels, when a ramp is supplied, the slider
should be positioned so that in its rearmost position it is clear of the
ramp.
If any doubt exists relating to the correct position of the equipment
on the vehicle then the Fontaine Technical Department should be
consulted.
IMPORTANT
Fontaine cannot accept responsibility for any loss or damage
caused by equipment which has been modified or that has not
been fitted in an authorised manner.
I N S T A L L A T I O N
Figure 16 - Mounting Frame
Figure 17 - Sliding Fifth wheel
English
