- 6 -
EN
switchboard characteristics in order to adjust it to the amplifier input level.
15.-
TEL. VOLUME:
volume control for the TEl. iNPUT. it allows you to adjust the volume of the telephone
switchboard which is connected to the TEl. iNPUT terminal.
16.-
CHIME
: for selecting between the 2 and 4 tone chimes.
INSTRUCTIONS FOR USE
ZONE SELECTION WITH BACKGROUND MUSIC
Select the zones where you want the background music to be played, by pressing the corresponding ZONE
1 to 5 buttons on the front panel of the system.
The background music will be cut off when there is an announcement in one of the zones. Once the
announcement has finished, the background music will return to the selected zones.
CONNECTING THE M-512 MICROPHONE
To connect the m-512 model microphone to the system, use the cable supplied with the microphone.
The microphone is powered through the audio and data cable. in the case of the distance being more than
10 m there could be loss through the audio and data cable. Therefore, the microphone should be powered
with a local 24 V DC power supply with the supplied cable.
PAGING WITH THE M-512 MICROPHONE
Select the zones where you want the announcements to be sent, using the CH 1 to 5 buttons on the
microphone and then press the TAlK button. When the announcement has finished, press the TAlK button
again and disable the zone selection in the
M-512
model microphone.
Note
: The zone selection is disabled in the amplifier while there is a zone selected in the
M-512
model
microphone.
CHIMES
The chimes can be used in 3 ways:
The chimes can be reproduced at a distance through the microphone mod. m-512. firstly, select if you want
to activate 2 or 4 chime tones on the back panel of the microphone. Then, select the zone or zones where
you want the announcement to be sent using CH 1 to 5 buttons and press the CHimE button to send it. The
TAlK button must be pressed down for the chimes to be played.
To play the chimes from a distance, firstly, you must activate the chimes on the front panel using the SiREN
CHimE button. Then you have to select the o or 4 chime tones on the back panel of the amplifier. Afterwards,
in order to play the chimes you have to close the CHimE ACTiVE contacts on the back panel using the push
button (or the microphone push button).
in order to play the chimes from the amplifier, they must be activated on the front panel using the SiREN
CHimE button. Select if you want 2 or 4 chime tones on the back panel of the amplifier. Then, play the chimes
with the CHimE ACTiVE button on the front panel.
SIREN
To play the siren from the amplifier, it must be activated on the front panel with the SiREN button. Use the
VOlUmE control button to adjust the volume in the siren output.
When you activate the siren, you will only be able to hear it in the selected zones.
Note: So that the siren has priority depending on the level, the VOlUmE control must be at least at mid
volume.
EMC EMERGENCY INPUT
When a signal is detected in the EmC input, this is sent to all output zones at maximum volume.
INPUT PRIORITY
The priority function automatically weakens the input levels with lower priority so that the message sent out
by those with higher priority can be heard clearly.
The EmC input has maximum priority over the rest of the inputs. The EmC input priority is activated when a
signal is detected in the input connector, automatically weakening the TEl. iNPUT, the microphone model
M-512
signal, miC 1 to 4 and liNE 1 and 2 inputs so that the message can be heard clearly.
