DESCRIPTION
- 2-channel power amp.
- 2 x 500 W RMS. Loudspeaker output 4 and 8 Ω, 100 and 70 V lines.
CONTROLS AND FUNCTIONS
FRONT PANEL
1.-
CH 1/CH 2
: volume control wheels for channels 1 and 2. It is recommended that you do not raise these
volume controls to their maximum. Position them at 3/4 for optimum results.
2.-
PROT
: LED protection indicators. They light up when protection is activated due to a surge or short-
circuit. With protection activated the audio output is cut off.
3.-
TEMP
: LED temperature protection indicators. They light up when protection is activated due to excess
temperature inside the equipment. With protection activated the audio output is cut off.
4.-
CLIP
: LED peak signal indicators. They light up when an input signal is detected with a level that is too
high in the corresponding channel or when there is an excess output level that could damage the
equipment.
5.-
SIGNAL
: LED indicators that light up when an input signal is detected in channels 1 and 2.
6.-
Power amplifier on/off switch.
7.-
ON
: LED power indicator for the power amplifier.
BACK PANEL
1.-
LINK
: balanced signal output for channels 1 and 2 for connecting several pieces of equipment in
cascade. XLR connector.
2.-
INPUT
: balanced signal input for channels 1 and 2, XLR connector.
3.-
GND LIFT
: this selector is normally in the GND position. If the installation has mass noises, move the
selector to the LIFT position to disconnect the mass and the earth from the equipment.
- 4 -
EN
