FOLSOM 2100DE, Installation And Operator'S Manual

Page: 14 / 62

Manual # 26-6092936-00 / Revision A VFC-2100DE
– Scaler with Digital Effects
7
Video Input Connections
The video input section on the VFC-2100DE rear panel contains one pair of 15-pin SUB-D input connectors.
1)
If you are using a PC with a 15-pin VGA connector, connect the video output of the PC to the 15-pin SUB-D
connector input labeled “Video In A” on the VFC-2100DE rear panel.
2)
If video inputs will be looped through the VFC-2100DE to a high resolution graphics monitor, connect the
input of the VGA monitor to the 15-pin SUB-
D connector input labeled “Video Loop A” on the VFC-2100DE
rear panel.
3)
You will need to select the input port and termination via the VFC-2100DE rear panel switch. It is important
to have the termination set correctly for each installation. If the termination is not set correctly, the unit may
not work properly. Generally, the VFC-2100DE is installed between the computer workstation and the
computer monitor. In this case, the termination setting should be set to
HI-Z . Monitors typically either have
built-in 75-ohm termination or have a provision to terminate or un-terminate at the monitor via switches or a
BNC loop-through.
Termination should always be at the end of the video chain .
Video Output Connections
RGB Video Output: Connect the output device to Output #1 on the output section of the VFC-2100DE rear panel.
Select the desired output format via the front panel menus or serial link.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com