Service
Dispense chute cover removal
1. Remove top cover.
2. Push chute cover up vertically to slip off
holding tab.
3. After clearing tab, pull chute cover forward
to remove.
Auger motor assembly removal
1. Remove top cover.
2. Remove one thumbnut on rear of motor bracket.
3. Lift motor bracket and motor up, unplug electric
quick disconnects and remove.
Dispense mechanism assembly removal (Fig. 2)
1. Remove top cover.
2. Remove chute cover (see above).
3. Remove auger motor assembly (see above).
4. Remove quick release pins from the ice chutes
and gates, then unplug wires from solenoids.
5. Lift dispense mechanism up and off auger tube.
Auger and auger tube removal (Fig. 3)
1. Remove auger motor and dispense mechanism
assembly (see above).
2. Pull auger upward to clear auger tube.
3. Lift auger tube upward to clear dispenser top.
4. Slide tube and bearing plate through auger
tube gasket.
Dispense wheel removal
1. Remove drain pan assembly and bin access
cover.
2. Remove center thumbnut and threaded rod on
dispense wheel assembly and lift wheel out
front access opening.
solenoid
quick
release
pin
quick
release
pin
gate
ice
chute
Dispense assembly, top view
(RH unit with bath shown)
RH, 8-valve unit
Front View
dispense
chute
drain pan
assembly
valves
chute
cover
top cover
Fig. 1
Fig. 2
2
wheel
motor
baffle
plate
wheel
motor
mounting
plate
dispense
wheel
auger
tube
auger
auger motor
Side View
auger
bearing
plate
stationery
agitator
rotating
agitator
dispenser
Front View
Fig. 3
12
