Horizon HCD700R/N, HMD700R/N Ice Machines
21
Fig. 21
13. To remove the rear bushing, place the auger into the
evaporator and use it to gently tap and dislodge the
rear bushing housing
(Fig. 21).
Fig. 22
Evaporator reassembly
1. Remove and inspect O ring seal. Replace if
damaged in any way.
2. Place rear bushing into evaporator.
3. Install the three bolts: partially tighten each bolt,
alternating bolts until the rear bushing is fully seated
and properly aligned
(Fig. 22).
4. When fully seated, remove the bolts.
Fig. 23
5. Install the reservoir with three bolts (Fig. 23).
