10
Before turning power on
1. Clean and sanitize ice storage bin in accordance with cleaning procedure in ice storage bin installation
information packed with ice storage bin.
2. Turn water to ice machine on.
3. Remove cover on fl oat reservoir.
4. Push down on fl oat to force water out overfl ow tube and into evaporator drain pan.
5. Check that water drains freely from evaporator drain pan.
6.
Lift
fl oat and check that fl oat valve shuts off incoming water when raised.
After turning power on
1. Turn power to ice machine on and confi rm that gearmotor, compressor and
fan motor start immediately.
2. Check that ice begins to enter bin within approximately 10 minutes.
3. With ice machine running, check that fl oat reservoir water level is approximately 10mm (3/8") below internal
overfl ow and adjust to this level (raised line on side of reservoir) if necessary.
4. After making ice for 10 minutes, put ice against ice level control stat cap tube and check that ice machine
shuts down.
5. Warm ice level control stat with your fi ngers and check that ice machine restarts in approximately 20 minutes.
(Bin must be calling for ice.)
