8
15CI100A with Rear Drain
Optional Leg Accessory Installation
CAUTION!
Use caution when tipping the dispenser during leg installation. Do
not lay unit on back or side. DO NOT EXCEED 30° angle. Tipping
more than 30° can result in compressor malfunction.
1 . If installing optional 4" Leg Accessory (item# 00956300), place a
5" (12.7 cm) spacer underneath the dispenser to ease installation.
2 . Remove four plastic, thread-protecting plugs from bottom of
dispenser.
3 . Screw each leg into chassis (Fig . 3).
Fig . 3
Optional Internal Water Filter Installation
If your dispenser has the internal water filter option, the water filter
must
be
installed for the dispenser to operate. Because internal components will need
to be accessed for both procedures, Follett recommends installing the water
filter just prior to initial sanitizing.
1 . If installing the optional internal water filter, please complete the
steps shown in
Accessing Internal Components on page 9
before proceeding.
2 . Lift and remove the top panel, set aside (Fig . 4 .1).
3 . Remove two screws (Fig . 4 .2) and remove left side panel.
4 . Install filter as shown. Turn filter clockwise until it is fully seated
(Fig . 4 .3).
Fig . 4
1
2
3
spacer
5" (12.7 cm)
min.
Summary of Contents for chewblet 15CI100A
