ENGLISH
equipment Setup
Attach Air Filter
The air intake filter and cover are packed in the top of the carton.
Place the filter cartridge over the bracket at the rear of the power head
and hold it against the rear housing. Screw filter cover into the bracket
and tighten snugly.
Install Tank Liner
Loosen tank clamps and lift power head from tank. Remove extra
plastic tank liners from tank.
Open a protective plastic tank liner and position it inside the tank
(new units ship with a tank liner in place). The top of the liner should
extend over and outside the top lip of the tank.
NOTE: Although the stainless steel of the Vectra-Jet fogger
offers a measure of protection against chemical corrosion, we
nonetheless also recommend use of the plastic tank liners as
an additional barrier.
Add fogging liquid to the tank (inside the tank liner). Confirm that
the tank gasket is in place inside the lip of the cover plate. Put the power
head on the tank and fasten clamps to secure it.
Adjust Flow Rate
Plug the fogger power cord into a grounded (earthed) outlet and
turn power switch ON.
Adjust liquid valve for the desired fog droplet size. Push the red ring
of control valve in to lock valve setting (out to release).
8
