Envy models only :
There are no imitation fuel bed components to install. The appli-
ance features a ribbon burner which is designed to produce a continuous band of flame
over it’s length. The burner should be visually inspected to ensure it is free from any
foreign matter.
If it is necessary to clean or dust off the burner then (if fitted) the glass door should be
removed by removal of the four retaining screws. Re-fit the glass door after cleaning or
inspection, ensuring a good seal.
Blenheim & Horizon models only :
The burner should be visually inspected to
ensure it is free from any foreign matter. If it is necessary to clean or dust off the burn-
er then (if fitted) the glass door should be removed by removal of the four retaining
screws. Fit the fuel bed as described in section 7.3.
All models :
The gap between the spark electrode and the pilot should be 3.5 - 4.5mm to produce a good spark. There should
be no need to adjust this. If under any circumstances the piezo electric spark fails, the pilot cannot be lit manually.
The appliance features a coal style fuel effect.
1. Place the rear coal strip onto the shelf behind the burner
as shown in figure 15. Ensure that the four protruding screw
heads engage the hollow areas on the underside of the piece.
2. Position the front coal piece onto the front of the burner
as shown in figure 16.
Re-fit the glass panel using 4 M6 screws.
The fire is designed to operate correctly with the supplied
components according to the instructions. Never add coals.
Never put combustible or non-combustible materials, rub-
bish or other matter into the fire.
Figure 14
Figure 15
Figure 16
©
2013 Focal Point Fires plc.
7.2 CHECKING THE BURNER AND SPARK GAP
GB IE
7.3 FITTING THE FUEL BED (Blenheim & Horizon models)
10
Figure 13
Spark gap
