Operating Instructions
PREMA
xx
Electrical Pump
Assembly of PREMA
xx
electrical pump
1.
Push the transparent suction hose (6) onto the suction pipe with filter (8).
2.
Push the hose clamp (7) over the suction hose (6) to the suction pipe (8) and tighten the
hose clamp with a screwdriver.
Note
Before continuing with the next Step, please note:
If the pump is mounted on the fuel container, the suction hose with the suction pipe must be
long enough to reach the fuel in the tank even if the fuel level is low.
3.
Cut the suction hose (6) to the desired length.
4.
Push the hose clamp (5) over the suction hose (6).
5.
Push the suction hose (6) onto the vacuum union (4) on the pump.
6.
Push the hose clamp (5) to the vacuum union (4) and tighten the hose clamp with a
screwdriver.
Danger!
Hoses with insufficient resistance can cause explosions
In order for the fuel to be delivered without risk, the delivery hose must have a certain
resistance in order to avoid static charge. The original delivery hose from FMT has the
necessary resistance.
Use only FMT delivery hose.
When using delivery hoses by other manufacturers make sure that the delivery hose has a
resistance of > 10
11
Ohm.
Caution!
Risk of product damage
Mount and operate the pump only vertically on a fuel container.
7.
Firmly screw the pump into the aperture of the fuel tank using the barrel screw joint (3).
The pump run-off can be brought into any position in the screwed-in state by twisting the
pump housing (1).
8.
Screw the union nut (14) of the black delivery hose onto the pressure union (13) of the
pump.
9.
Screw in the free end of the delivery hose with the external thread (16) into the thread of
the nozzle (11 or 20 respectively).
Caution!
Risk of product damage
The power source must have the correct voltage for the pump type.
10.
Connect the pump to a power source using the main plug.
The pump is ready for operation.
7
