FMS EMGZ622A, Operating Manual

Page: 21 / 39

Operating Manual EMGZ622A/642A
21
9.4 Description of the Parameters: System Parameters
The parameter changing mode is activated by pressing the
PARA
↵
key for 3 seconds. By
pressing the
PARA
↵
key again, the global parameters are selected (ref. also to fig. 11).
Generally, the parameters are settable using the keys as follows:
choose
switch the selections or increase / decrease numeric values
change the decimal (while inputting a numeric value)
enter
Language
Use: This parameter stores the display language.
Range: English, French, Italian, German
Measuring system
Use: This parameter indicates the measuring system to be used. If it is set to
metric , all force values are shown as [N, cN, kN]. If it is set to US
standard , all force values are shown as [lb, clb, klb].
Range: Metric, US standard Default: Metric
Lowpass display
Use: The electronic unit provides a low-pass filter to prevent noise which is added
to the integrated display. This parameter stores the cut off frequency. The
lower the cut off frequency, the more sluggish the output signal will be. Due
to this filter, the value shown in the display will be much more stable in the
case of high fluctuations of the force value.
The low-pass display filter is independent to the other filters.
Range: 0.1 to 10.0 Default: 1.0
Increment: 0.1 Unit: [Hz]
Identifier
Use: This parameter stores the ident number of the device when linked to
PROFIBUS, CAN-Bus resp. DeviceNet.
Range: 0 to 127 Default: 84
Increment: 1 Unit: [-]
Baud rate
Use: This parameter stores the speed of the serial interface (RS232). The other
settings are fixed: 8 data bits, even parity, 1 stop bit („8 e 1“).
Range: 2400, 4800, 9600, 19200 Default: 9600
Unit: [Baud]
↵
↑ ↓
←
↵