FMS EMGZ622A, Operating Manual

Page: 23 / 39

Operating Manual EMGZ622A/642A
23
Sensitivity
Use: This parameter stores the sensitivity of the force sensor, that means how
much signal per volt excitation the sensor will give when loaded with
nominal force. Standard for FMS force sensors is 1.8mV/V.
Range: 0.1 to 5.0 Default: 1.8
Increment: 0.1 Unit: [mV/V]
Min. limit
Use: The event „Min. limit passed under“ will be performed if the tension
feedback passes under the threshold value stored here.
If the parameter contains a zero value, limit switch monitoring is inactive.
Range: A force value can be input. The value consists of 5 digits. The position of
the decimal point depends on the parameter
Force of sensor.
Default: 0
Unit: [N, kN, cN]
or [lb, klb, clb]
Note: The event can be shown using a LED (ref. to parameter Config. of LED ) or
fed to the digital outputs (ref. to parameters Dig.Out.1 and Dig.Out.2 ).
Max. limit
Use: The event „Max. limit passed over“ will be performed if the tension
feedback passes over the threshold value stored here. All other function is
identical with
Min. limit . Default: 1000
Config. of LED
Use: This parameter defines which event will activate the LED on the operating
panel.
Range: Min., Max., Error, Okay Default: Max.
Dig.Out.1
Use: This parameter defines which event will activate the digital output 1. The
digital output is operated as „open collector“ output (ref. to wiring
diagram).
Range: Min., Max., Error, Okay Default: Min.
Dig.Out.2
Use: This parameter defines which event will activate the digital output 2. The
digital output is operated as „open collector“ output (ref. to wiring
diagram).
Range: Min., Max., Error, Okay Default: Max.