Operation Manual EMGZ 490
15.12.2015
14
Used MAC address
Device
Status
MAC address
IP - address
Description
With new
firmware
00:1F:88:00:00:00 192.168.0.90
If the EMGZ490 was loaded with new
firmware or a firmware update has
been done, the standard MAC-address
used. This address will be valid until
the definitive MAC - address is
assigned.
MAC
assigned
00:1F:88:xx:xx:xx
0.0.0.0
The area designated with x is the part
of the MAC-address that can be
assigned via the web interface. It is
the free area that is managed by FMS.
Each device receives a unique MAC-
address within this area. The front
area 00:1 F: 88 is the vendor range.
This is the ID that identifies the device
as a FMS product worldwide.
5.4
TCP/IP Configuration
In order to enable data communication between amplifier and a PLC or a web browser,
the Ethernet settings must be known. In a PROFINET-network the system designer
configures the address for each device and has therefore an overview over the
distribution of the addresses in the network. The IP-address is assigned to each device
via the PLC. The device must have an IP-address of 0.0.0.0 after power up to enable the
assignment of the final IP-address. This is the case after each EMGZ 490 restart.
Static IP-address:
A static IP-address is required to enable the PLC accessing a web interface. The IP-
address of 0.0.0.0 cannot be used for this purpose, as this address is treated in a
special way according to TCP / IP–specification. Devices with this IP will not response, if
an inquiry over the web browser is started.
