www.fmiproducts.com
116200-01N
26
FIREPLACE INSTALLATION
Continued
Figure 42 - Placing Ember Material on
Burner
Embers
Plenum
WARNING: The glass door
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
7. Replace louvers by reversing procedure
under
Removing Louver Panels,
page 25
for (V)VC36 series.
8. Replace screen door assembly, see remov
-
ing screen door assembly, page 25, for (V)
VCC36 series.
Cleaning Glass Door
See
Cleaning and Maintenance
on page 31.
INSTALLING LAVA ROCK AND
GLOWING EMBERS
It is very important to keep logs exactly as
installed. Do not modify logs. Only use log set
designed for this fireplace. Logs under log/grate
assembly are attached to burner. Do not attempt
to move these logs as this will damage logs.
WARNING: Logs are unitized
and attached to the grate. Do not
handle log/grate assembly by
logs. Always pick up by grate.
Open louvers, remove screen, unlock door
latches and open glass door. See
Removing
Glass Door
, steps 1 and 2, page 25.
1. Pull ember material apart into pieces no
larger than a dime. Place these pieces
loosely and sparingly directly onto exposed
front section of burner (see Figure 42). This
will create the glowing ember appearance
as flame touches ember material. Do not
block air slots by using too much ember
material in one area. Place small pieces of
ember material to cover pilot ports. It is not
necessary to use all of the ember material
provided.
2. Pour lava rock onto plenum but not onto
flat burner. It is not necessary to use all
of the lava rock provided.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner will cause
performance problems.
3. Close glass door, lock door latches, replace
screen and close louvers (see
Removing
Glass Door
, steps 5 through 7, page 25).
