www.fmiproducts.com
112301-01E
5
Figure 2 - Typical Two Sided Fireplace
Installation
INTRODUCTION
Models (V)GL36CR(P)/CL(P) are decorative gas
fireplaces that use a millivolt gas control valve with
millivolt ignition system. Models (V)GL36CR(P)
E/CL(P)E use an electronic gas control valve with
electronic ignition system.
These systems require a 6" B-type vent that is not
supplied by FMI PRODUCTS, LLC. For installa-
tion guidelines, check your B-vent instructions.
WARNING: This gas appli-
ance must not be connected to
a chimney flue servicing a solid
fuel burning appliance.
If you are uncertain as to what gas your unit is ap-
proved and tested for, check rating plate on inside
of fireplace opening or consult your local distribu-
tor of FMI PRODUCTS, LLC products.
BEFORE YOU BEGIN
Before beginning the installation of your appli-
ance, read these instructions through completely.
This FMI PRODUCTS, LLC appliance and its
approved components are safe when installed
according to this installation manual and are oper-
ated as recommended by FMI PRODUCTS, LLC.
Unless you use FMI PRODUCTS, LLC approved
components tested for this appliance,
YOU MAY
CAUSE A FIRE HAZARD!
The FMI PRODUCTS, LLC warranty will be voided
by and FMI PRODUCTS, LLC disclaims any respon-
sibility for the following actions :
A) Modification of the appliance or any of the
components manufactured by FMI PROD-
UCTS, LLC unless otherwise permitted by
FMI PRODUCTS, LLC.
B) Use of any component part not approved by
FMI PRODUCTS, LLC in combination with
this appliance.
C) Installation and/or operation in a manner other
than instructed in this manual.
D) The burning of anything other than the type of
gas approved for use in this gas appliance.
This appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the
National Electrical
Code, ANSI/NFPA 70
.
The installation must conform with local codes or, in
the absence of local codes, with the current
National
Fuel Gas Code, ANSI Z223.1/NFPA 54
.
This appliance complies with
ANSI Z21.50
as a
Vented Gas Appliance
and is listed and tested by
the
PFS Corporation
.
WARNING: Installation and
repair should be done by a quali
-
fied service person. The appliance
should be inspected before use
and at least annually thereafter by
a qualified service person. More
frequent cleaning may be required
due to excessive lint from carpet
-
ing, bedding etc. It is important
that the control compartments,
burners and circulating air systems
be kept clean.
NOTICE: This appliance is not
intended to be used as a primary
source of heat.
SELECTING LOCATION
To determine the safest and most efficient location
for your appliance, you must take into consider-
ation the following guidelines:
1. The location must allow for proper clearances
(see
Clearances,
page 6).
2. The location should be in a place where drafts,
air conditioning ducts, windows or doors will
not affect fireplace heat output.
3. A location that avoids the cutting of joists
or roof rafters will make installation easier.
Figure 2 shows a typical two-sided fireplace
installation.
Existing
Side
Wall
4" From Opening to
Perpendicular Wall
Access
Control Panel