www.fmiproducts.com
116647-01H
30
OPERATING FIREPLACE
Continued
OPTIONAL REMOTE
OPERATION
Note
: The WRC receiver and hand-held
remote control kit must be purchased
separately (see
Accessories
, page 39).
Follow installation instructions on page 27.
1. Turn equipment shutoff valve to ON posi
-
tion. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT
:
Be sure to press the ON/
OFF buttons on the hand-held remote
control unit for up to 3 seconds to as
-
sure proper operation.
2. Press the ON/OFF button to turn the
burner on and off.
OPERATING OPTIONAL
BLOWER ACCESSORY
Locate the blower controls by opening the
lower louver panel on the fireplace. Blower
controls are located on the left side of the
switch bracket to the right just inside the
louver panel.
The BK manual blower and the BKT
thermostatically-controlled blower have an
ON setting and an OFF setting. The blower
will only run when the switch is in the ON
position. In the OFF position, the blower
will not operate.
Note for BKT Only:
If you are using BKT
blower with optional thermostat (wall
mounted or remote control) for the fire
-
place, your fireplace and blower will not
turn on and off at the same time. The
fireplace may run for several minutes
before the blower turns on. After the fire
-
place modulates to the pilot position, the
blower will continue to run. The blower
will shut off after the firebox temperature
decreases.
The blower helps distribute heated air
from the fireplace. Periodically check the
louvers of the firebox and remove any
dust, dirt or other obstructions that will
hinder the flow of air.
INSPECTING BURNERS
Check pilot flame pattern and burner flame
patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the
proper flame. Alterations may have occurred
Figure 51 - Typical Flame Pattern
CLEANING AND
MAINTENANCE
WARNING: Turn off fireplace
and let cool before cleaning.
CAUTION: You must keep
control areas, burners and
circulating air passageways of
fireplace clean. Inspect these
areas of fireplace before each
use. Have fireplace inspected
yearly by a qualified service
person. Fireplace may need
more frequent cleaning due to
excessive lint from carpeting,
bedding material, pet hair, etc.
during shipping and handling. The pilot is
located on the left hand side of the burner.
The flame must envelope 1/4" of top of the
ignitor/sensor and grounding stem.
If your pilot assembly does not meet these
requirements:
• Turn the adjustment screw marked PILOT
clockwise to decrease or counterclockwise
to increase the flame to proper size (see
Figure 49, page 28). Do not remove the
adjustment screw.
• see
Troubleshooting
, page 31
BURNER FLAME PATTERN
Burner flames will be steady; not lifting or float
-
ing. Flame patterns will be different from unit
to unit and will vary depending on installation
type and weather conditions.
If the vent configuration is installed incorrectly,
the flames will lift or "ghost". This can be dan
-
gerous. Inspect the flames after installation to
ensure proper installation and performance.
Figure 51 shows a typical flame pattern.
If burner flame pattern differs from that de
-
scribed:
• turn fireplace off (see
To Turn Off Gas to
Appliance,
page 29)
• see
Troubleshooting
, page 32
