www.fmiproducts.com
125568-01A
27
VARIABLE REMOTE MODELS OPERATION
Continued
TO TURN OFF GAS
TO APPLIANCE
1. Turn control knob clockwise
to the
OFF position.
2. Set selector switch in the OFF position.
3. Close equipment shutoff valve (see Figure
15, page 15).
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under Lighting
Instructions
, page 26.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow steps 9
through 11 under Lighting Instructions
,
page 26.
BLOWER
OPERATION
WARNING: This fireplace has
a three-prong, grounded electrical
plug. This plug helps protect you
against electrical shock. Only con-
nect plug to a properly grounded,
three-prong receptacle. Do not cut
or remove the grounding prong
from this plug.
Locate the blower switch by opening lower
louver on fireplace. Blower switch is located
at lower center inside louver door.
Note: It is safe to operate fireplace with blower
turned off. However, the blower helps distribute
heated air from the fireplace.
Note: Periodically check the louvers of the
firebox and remove any dust, dirt or other
obstructions.
Figure 39 - Pilot (Natural/ Propane/LP)
HAND-HELD
REMOTE OPERATION
BATTERIES
WARNING: Make sure your
selector switch is in OFF posi-
tion before installing or chang-
ing batteries in your hand-held
remote or receiver.
For installing or replacing batteries in remote
control or receiver, see
Installing Batteries in
Remote Control and Receiver on page 17.
Low Battery - Hand-Held Remote Control
When batteries in hand-held remote control
are low, an icon will appear on display.
Low Battery - Remote Receiver
When batteries in receiver are low, no acoustic
signal will be given when ON/OFF button is
pressed. If batteries in receiver are low, fireplace
can be switched on manually by moving remote
selector switch to ON (see Figure 40).
ON
Figure 40 - Low Battery Display
FAHRENHEIT/CELSIUS INDICATOR
You can set your hand-held remote control to
display the temperature in either Fahrenheit
or Celsius. With remote control off, press
THERMOSTAT button and MODE button at
the same time. This will toggle the display
from °F to °C.
Figure 41 - Remote Control Display
Fahrenheit to Celsius
Pilot
Burner
I
gnitor
Electrode
