www.fmiproducts.com
125566-01A
21
inStallation
Continued
7
Figure 35- Installing Log # 7
Place the right crossover log (#7) on top
7.
of the middle log and rear log as shown
in Figure 34. Match the roung peg on the
top of the rear log with the round hole on
the bottom of the right crossover log and
square peg on the top of the middle log
with the square hole on the bottom of the
right crossover log.
Match the round hole on the bottom of the
8.
center crossover log (#8) with the metal
pin on the top of the right crossover log.
Rest the front of the center crossover log
on top of the front right log and against
the grate. See Figure 365
9. Final Assembly is shown in Figure 36.
8
Figure 35- Installing Log # 8
Figure 36- Final Assembly
LTF(18,24,30)-MM LOG PLACEMENT
It is very important to install the logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater or as identified for use
with the heater as shown in Figure 20, page
17. Each log includes reference numbers
formed in the bottom or back of the log. The
circled number indicates the order it is placed
on the burner system. The remaining numbers
indicate the size burner system the logs are
designed to fit. For example, the first log for
a 24 inch burner system will include a circled
1 and also a 24. The circled 1 indicates this
is the first log to be installed. The 24 indicates
this log belongs to a 24 inch log set.
See page
42 for reference numbers detail.
Place the rear log (#1) on base assembly
1.
as shown in Figure 37. Log will fit over
right end of burner and rest in middle
of U-burner.
1
Figure 37 - Installing Log # 1
''U'' -
Burner
Base
assembly
