www.fmiproducts.com
125010-01A
16
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
Each log is marked with a number. These
numbers will help you identify the log when
installing (see chart below). It is very important
to install these logs exactly as instructed.
Do not modify logs. Only use logs supplied
with heater.
Note: Your appliance may vary from model
shown but log placement will be the same.
1. Place fiber ramp-log in center on chassis
as shown in Figure 18. The fiber ramp-log
can be identified by its shape and much
lighter weight when compared to the other
logs.
2. The log must sit flat on the black sheet
metal and behind the left metal tab as
shown in Figure 19.
3. Place front left and right logs and rear log
as shown in Figure 20.
4. Place top left log as shown in Figure 21,
page 17. The bottom of the log is shaped
to fit onto the recessed areas of the front
left log and the rear log. The recessed
areas are painted yellow.
5. Place top right log as shown in Figure 21,
page 17. The bottom of the log is shaped
to fit onto the recessed areas of the front
right log and the rear log. The recessed
areas are painted yellow.
Figure 18 - Installing Log Set
Base Assembly
Ramp
Log
Rear Log
Grate
Prongs
Front
Right Log
Front Left
Log
Figure 20 - Installing Logs
Figure 19 - Installing Log Set
Ramp
Log
Metal
Tab
Description
Log ID Number
EZC18
VULC18
EZC24
VULC24
EZC30
VULC30 Qty
Front Left Log
012
001
007
1
Front Right Log
013
002
008
1
Rear Log
014
003
009
1
Top Left Log
016
005
011
1
Top Right Log
015
004
010
1
Small Top Right Log
006
006
006
1
