With the slide switch in the OFF position (sway
from the LEARN button), the system is off.
It is suggested that the slide switch be placed
in the OFF position if you will be away from
the home for an extended period of time. If the
remote receiver is mounted out of the reach
of children, place the slide switch in the OFF
position also functions as a safety "lock-out"
by both turning the system off and rendering
the remote receiver inoperative.
(C)MRC
ON / OFF REMOTE CONTROL
FOR USE IN FMI PRODUCTS, LLC MANUFACTURED
"REMOTE READY" GAS HEARTH PRODUCTS
The remote operated on a 12V battery (included)
PDGHVSHFL¿FDOO\IRUUHPRWHFRQWUROVDQGHOHFWURQLF
lighters. Install the 12V battery supplier with the unit
into the battery compartment.
It is recommended that Alkaline batteries always
be used for longer battery life and maximum op-
erational performance.
The remote has On and Off functions that are
activated by pressing either button on the face of
the transmitter. When a button on the transmitter is
pressed, a signal light on the transmitter illuminates
EULHÀ\WRYHULI\WKDWDVLJQDOKDVEHHQVHQW8SRQ
initial use, there may be a delay of three seconds
before the remote receiver will respond to the re-
mote control. This is part of the system's design.
If the signal light does not illuminate, check the
position of the transmitter battery.
ON
OFF
12V
BATTERY
COMPARTMENT
K
C
A
B
T
N
O
R
F
SIGNAL
LIGHT
ON/OFF
BUTTONS
RECEIVER
The remote receiver operates on 4 AA-size 1.5 Volt bat-
teries. IMPORTANT: New or fully charged batteries are
essential for proper operation of the remote receiver.
The remote receiver houses the microprocessor
that responds to commands from the transmitter
to control system operation. The receiver has a
3-position slide switch for selecting the MODE of
operation: ON/REMOTE/OFF.
With the slide switch in the ON position
(toward the LEARN button), the system will
remain on until the slide switch is placed in
the OFF or REMOTE position.
With the slide switch in the REMOTE position
(centered), the system will only operate if the
remote receiver receives commands from the
remote control.
REMOT
E
N
O
FF
O
LEAR
N
ADJ.
Requires 4-AA 1.5V
alkaline batteries
Learning
button
Frequency
adjusting
access hole
Remote Receiver
Battery cover slides on/o
ff
Slide
Switch
ON
REMOTE
OFF
Figure 1: Remote Control
Figure 2: Remote Receiver
WARNING: This remote control
system must be installed exactly as
outlined in these instructions. Read
all instructions completely before
attempting installation. Follow in-
structions carefully during installa-
WLRQ$Q\PRGL¿FDWLRQVRIWKHUHPRWH
control or any of its components will
void the warranty and may cause a
¿UHKD]DUG
Do not connect any gas valve or elec-
tronic module directly to 110-120VAC
power. Consult gas appliance manu-
facturer's instructions and wiring
diagram for proper placement of
all wires. All electronic modules are
to be wired to the manufacturer's
VSHFL¿FDWLRQV,PSURSHULQVWDOODWLRQ
of electrical components can cause
damage to electronic module, gas
valve and remote receiver.
