www.fmiproducts.com
125271-01A
2
INSTALLATION
The remote receiver can be either wall-mounted
in a standard plastic switch box or placed on or
QHDUWKH¿UHSODFHKHDUWK3UHIHUDEO\WKHUHPRWH
receiver should be wall-mounted in a plastic switch
box, as this will protect its electrical components
from both the heat produced by the gas appliance
and potential damage or abuse that can occur if it
is left exposed on the hearth. PROTECTION FROM
EXTREME HEAT IS VERY IMPORTANT. Like any
piece of electronic equipment, the remote receiver
should be kept away from temperatures exceeding
130
°
F inside the receiver case. Battery like is also
VLJQL¿FDQWO\VKRUWHQHGLIEDWWHULHVDUHH[SRVHGWR
high temperatures.
Make sure the remote receiver switch is in the OFF
position. It is recommended that 18 gage solid or
stranded wires with no splices and measuring no
longer than 20 feet (not included) be used to make
connections between the terminal bloc on the mil-
livolt gas valve or electronic module and the wire
terminals on the remote receiver for wall-mount
installation.
R
E
M
O
T
E
ON
OFF
LEAR
N
ADJ
.
REMOTE
N
O
F
F
O
LEAR
N
ADJ.
WALL
Plastic Switch Box
Remote Receiver
Cover Plate
Receiver
Slide
Button
Wire terminals
Remote Receiver
Receiver
Slide
Button
REMOTE
OFF
ON
LEARN
ADJ.
Remote Receiver
Cover Plate
(Rear View)
Wall mounting
Install 4 AA-size Alkaline batteries in the remote
receiver. For best performance, remote receiver
batteries should be factory fresh when installed.
Very little battery power is required to operate the
remote receiver, the electronics are tuned to oper-
ate best when battery output is greater than 5.3
Volts. Four new batteries should provide an output
voltage of 6.0 to 6.2 Volts.
Be sure batteries are
installed with the (+) and (-) ends facing the
correct directions.
To attached cover plate to receiver box, position
the receiver as shown in Figure 3 to the left with
the lower tab on cover plate inserted into groove of
receiver. Make sure ADJ hole and LEARN hole on
cover plate align properly with remote receiver. Pull
receiver up and snap into top tab of cover plate.
Position the cover plate so the word ON is facing
up, then, install the remote receiver into the plastic
switch box using the two long screws provided.
Push the white button over the receiver slide
switch only after making sure the remote receiver
has "Learned" the transmitter's security code (see
Matching Security Codes
).
NOTE: The remote receiver will only respond to
the transmitter when the 3-position slide button is
in the REMOTE position. If the system does not
respond to the battery transmitter on initial use,
see
Matching Security Codes
, and recheck battery
positions in the remote receiver.
Hearth Mount
7KHUHPRWHUHFHLYHUFDQEHSODFHGRQWKH¿UHSODFH
KHDUWKRUXQGHUWKH¿UHSODFHEHKLQGWKHFRQWURO
access panel. Position where the ambient tem-
perature inside the receiver case does not exceed
130
°
F. NOTE: Black slide button is used for hearth
mount applications.
WIRING INSTRUCTIONS
$ TXDOL¿HG HOHFWULFLDQ RU JDV WHFKQLFLDQ ZKR LV
familiar with the gas appliance and gas valves that
will be operated by the remote should install the
remote control system. Incorrect wiring connections
will cause damage to the gas valve or electronic
module operating the gas appliance and may dam-
age the receiver.
Figure 3: Mounting Receiver on Switch Plate
Figure 4: Mounting Receiver in Switch Box
Figure 5: Remote Receiver