background image

3

REQUIRED FOR COMPLETION

Radio Control System

The RTF version comes equipped with a Tactic™ TTX404 

four channel transmitter, 2.4GHz receiver, battery charger 
and AA transmitter batteries. The Tx-R “Prime” version of 
your Tidewater Sea Plane requires you supply your own 
battery, charger and four channel transmitter, so you’ll need 
to either purchase a Tactic TTX404 four channel 2.4GHz 
transmitter (TACJ2404) or any other 4-channel (or more) 
transmitter compatible with the Tactic 

AnyLink

™ 2.4GHz radio 

adapter (TACJ2000)*. Using the 

AnyLink 

allows any compatible 

transmitter to work with the Tactic receiver. 

* Visit Tx-Ready.com to see the 

AnyLink 

compatibility 

chart or contact Product Support at the contact 
information on page 3.

Battery

The motor and propeller combination included with the 
Tidewater Sea Plane uses the ElectriFly 11.1V (3S) 2200mAh 

30C LiPo battery (GPMP0861). If you have purchased the 

TX-R “Prime” you need to purchase the ElectriFly 11.1V (3S) 

2200mAh 30C LiPo battery (GPMP0861). Any other LiPo 
with similar specifi cations should also be suitable. While a 
larger battery may be a suitable alternative and has more 
capacity for theoretically longer fl ight times, the heavier weight 
can be detected in fl ight requiring slightly higher throttle 
settings for the same performance and only marginally longer 
fl ight times. Technical Info: At full-throttle with the included 
propeller the motor draws approximately 23A on the ground 
and approximately 20A in-fl ight. The average current draw in 
fl ight is approximately 12A for an average current consumption 
of approximately 205mAh per minute. Battery condition, fl ying 
style and weather conditions may cause performance to vary. 

The ESC included with the Tidewater Sea Plane comes with 

a Deans

®

 Ultra Plug

®

 connector. Any battery you purchase 

should have the same connector or an adapter allowing it to 
be used with the Deans

®

 Ultra Plug

®

 connector.

Charger

The RTF Tidewater Sea Plane comes equipped with a Great 

Planes

®

 3S LiPo balancing Smart Charger (GPMM3318). If 

you have purchased the TX-R “Prime” you need to purchase 
a charger. The Smart Charger is a safe way to charge your 
LiPo battery, but it’s very basic and just enough to get you 

started. The Smart Charger charges at a rate of .8 Amps, so it 
will take at least one-and-a-half hours or more to charge your 
battery. Eventually you’ll want to get more batteries and an 
advanced charger so you can charge faster and fl y more! For 
the most versatility, convenience and faster charging, the Great 
Planes ElectriFly

®

 Triton

 EQ AC/DC Charger (GPMM3155) 

is highly recommended as an upgrade charger. The Triton EQ 
may be powered either by an external DC power source (such 
as a 12V battery), or a 110V AC outlet and can charge your 
batteries in as little as a half-hour or less (depending on the 

condition of your batteries and the manufacturer’s specifi ed 
charge rate). The Triton EQ also has an LCD digital display 
screen so you can see how much capacity it took to charge 
the battery (handy for making calculations including fl ight 
time). The Triton EQ is a charger you can “grow into” because 
in addition to charging the LiPo batteries that will be used 
in your Tidewater, it can also charge many other types and 
sizes of batteries.

KIT INSPECTION

Before starting to build, take an inventory of this kit to make 
sure it is complete, and inspect the parts to make sure they 
are of acceptable quality. If any parts are missing or are not 
of acceptable quality, or if you need assistance with assembly, 
contact Product Support. When reporting defective or missing 
parts, use the part names exactly as they are written in the 
Kit Contents list.

Hobbico Product Support 

Ph: (217) 398-8970 ext. 5

3002 N Apollo Drive  Suite 1 

Fax: (217) 398-7721

Champaign, IL 61822

E-mail: [email protected]

ORDERING REPLACEMENT PARTS

Replacement parts for the Flyzone Tidewater EP Sea Plane 
are available using the order numbers in the Replacement 
Parts List that follows. The fastest, most economical service 
can be provided by your hobby dealer or mail-order company. 

To locate a hobby dealer, visit the Hobbico web site at www.

hobbico.com. Choose “Where to Buy” at the bottom of the menu 
on the left side of the page. Follow the instructions provided 
on the page to locate a U.S., Canadian or International dealer. 
Parts may also be ordered directly from Hobby Services by 
calling (217) 398-0007, or via facsimile at (217) 398-7721, but 
full retail prices and shipping and handling charges will apply.

Order No.

Description

REPLACEMENT PARTS LIST

Wing 

Fuselage 

Pylon 

Horizontal Stabilizer

Hatch 

Spinner 

Screw Set 

Motor

Float Set

Propeller Adapter

Servo 

9

u

4.5 Propeller

30A ESC

3S 11.1V 2200 Battery

F L Z A 6 3 2 5

F L Z A 6 3 2 6

F L Z A 6 3 2 7

F L Z A 6 3 2 8

F L Z A 6 3 2 9

F L Z A 6 3 3 0

F L Z A 6 3 3 1

F L Z A 6 3 3 2

F L Z A 6 3 3 3

F L Z A 3 6 6 4

G P M A 4 2 2 4

G P M Q 6 6 3 0

G P M M 1 8 3 0

G P M P 0 8 6 1

Summary of Contents for Tidewater





















Reviews: