background image

18

FAILSAFE NOT WORKING CORRECTLY

Receiver is not properly binded to the transmitter – bind 
the Rx to the Tx and re-try. Contact Hobby Services for 
further details.

WIRELESS TRAINING FUNCTION NOT BINDING

Check to see that another Tactic 2.4GHz system is not on 

in your area. The teacher’s and student’s transmitters were 
not powered in the proper sequence. Carefully follow the 
instructions on page 3 for proper binding and operation for 
training.

RECHARGEABLE BATTERIES WON’T ACCEPT CHARGE 

THROUGH THE TRANSMITTER

Check the charger for proper setup and operation. Make 
sure the charge plug is inserted fully into the charge jack. 
Make sure the transmitter’s power switch is in the OFF 

position. Make sure the cells are inserted inside the battery 
compartment in the proper direction.

FCC STATEMENT

This device complies with part 15 of the FCC rules. Operation is 

subject to the following two conditions.

(1) This device may not cause harmful interference.

(2)  This device must accept any interference 

received, including interference that may cause 
undesired operation.

FCC RF Radiated Exposure Statement:

 The equipment 

complies with FCC RF radiation exposure limits set forth for an 
uncontrolled environment. This equipment should be installed and 
operated with a minimum distance of 20 centimeters between 
the radiator and your body.

Note:

 

The manufacturer is not responsible for any radio or 

TV interference caused by unauthorized modifi cations to 

this equipment. Any changes or modifi cations not expressly 
approved by the party responsible for compliance could void 
the user’s authority to operate the equipment.

FCC ID: IYFTTX404B

CE COMPLIANCE INFORMATION

FOR THE EUROPEAN UNION

Instructions for Disposal of Waste Equipment by 
Private Users in the European Union:

This symbol on the product or its packaging indicates 

this product must not be disposed of with other 
household waste. Instead, it is the user’s responsibility 
to dispose of their waste equipment by handing it 

over to a designated collection point for the recycling of waste 
electrical and electronic equipment. The separate collection and 
recycling of your waste equipment at the time of disposal will 

help to conserve natural resources and ensure that it is recycled 
in a manner that protects human health and the environment. 
For more information about where you can drop off your waste 
equipment for recycling, please contact your local city offi ce, 

your household waste disposal service or location where you 

purchased the product.

Declaration of Conformity:

 

Product:

   Tactic TTX404 2.4GHz 

4-Channel Tx Rx

 

Item number:

 TACJ2404

 Equipment  class:

  1

Tactic TTX404  transmitter  and Tactic TR624  receiver:

The objects of the declaration described here are in conformity 

with the requirements of the specifi cations listed below, 
following the provisions of the European 2006/95/EC Low 

Voltage Directive:

EN 60950-1:2006 

Safety

The objects of the declaration described here are in conformity 

with the requirements of the specifi cations listed below, 
following the provisions of the European R&TTE directive 

1995/5/EC:

ETSI EN  300 328 V1.7.1 

Technical requirements for

  

radio 

equipment

ETSI EN  301 489-1 V1.8.1, 

General EMC requirements

 

301 489-17 V1.3.2  for radio equipment

Tactic  

c/o Hobbico, Inc.

2904 Research Road
Champaign, IL USA  61826

CE COMPLIANCE INFORMATION
FOR THE EUROPEAN UNION

The associated regulatory agencies of the following countries recognize the 
noted certifications for this product as authorized for sale and use.

UK

DE

DK

BG

SE

FI

EE

LV

LT

PL

CZ

SK

HU

RO

SI

AT

IT

ES

PT

IE

NL

LU

MT

CY

GR

1-YEAR LIMITED WARRANTY

* U.S.A. & Canada 

Tactic warrants this product to be free from defects in materials 

and workmanship for a period of one (1) year from the date of 
purchase. During that period, Tactic will, at its option, repair or 
replace without service charge any product deemed defective 
due to those causes. You will be required to provide proof of 
purchase (invoice or receipt). This warranty does not cover 
damage caused by abuse, misuse, alteration or accident. If 

Summary of Contents for Tidewater





















Reviews: