Flyer Upstreet6, Original Instruction Manual

Page: 191 / 271

25
EN
Do not connect the charger to the mains
socket immediately after a sudden tem -
perature change from cold to warm . It is
possible that condensed water has col -
lected on the contacts and this will lead
to a short circuit .
Do not connect the battery to the charg -
er immediately after a sudden tempera -
ture change from cold to warm . Wait until
both devices have reached room tem -
perature before connecting the charger
or the battery . Always charge and store
the battery and charger in a dry, covered
environment and only under supervision .
2 Check the LED charge status indicator
Check whether the charge status LED is lit up .
The LED lights up according to the charge status .
The charge status LED goes off when the charg-
ing process has been completed . The charging
time takes longer if the battery temperature is too
low or too high .
A fully charged battery cannot be charged any
further .
During charging, the following messages may be
displayed by the battery and charger via LEDs:
The battery may not be recharged when it
indicates a fault . The battery might
be damaged after being dropped or due
to mechanical impact, even when there
is no visible external damage .
Such batteries must therefore be in -
spected by a FLYER specialist retailer .
Never try to open a battery or to repair it .
Damaged batteries must not be posted .
3 Pull out the power plug from the plug socket
After disconnecting the battery from the charger,
disconnect the power supply plug from the wall
socket .
Before using the battery, be sure to firmly tighten
the rubber cap .
Inserting the battery
First, place the battery into the lower holder of the
e-bike and move its upper part towards the ve-
hicle until the lock audibly latches into the upper
holder . Ensure that the battery is correctly posi -
tioned in the holder .
upper holder
Prevent extreme overheating due to ex -
ternal effects or overloading. Only use
the battery with your FLYER .
• Never use a damaged battery . If you
discover cracks, deformation of the
housing or leaks, stop using the bat -
tery and have your FLYER checked
by a specialist retailer . Damaged bat -
teries must not be posted .
• The light will continue to function for
approx . two hours after the battery is
empty .