Oblò / Oblò
-
A
/
P
(
Autopilot)
User’s manual
Flybox
21
Rev.3.7
®
Standard Oblò installation
If you use a transponder with serial input for
receiving the altitude data, it can be connected to
the Oblò by following this steps:
-
To enable the transponder output it's required to
connect a 10Kohm resistor between pin#1 and pin#14
(whether or not it's connected the external GPS on
pin#14).
- Ensure there is a shared ground between the Oblò and
the transponder.
- Wire a serial transmit line, using shielded cable, from
the Oblò (pin#6 of the connector) to the respective
receive connection on the transponder. The serial out
of the Oblò is RS232 type, refer to the transponder
manual for its installation and configuration.
Electrical installation
1.3 ALTITUDE SERIAL OUT FOR
TRANSPONDER CONNECTION
Summary of Contents for Oblo
